horizontal-slide
TWISTEE SADDLE DN150

Connecting any DN150 lateral (Supersleve, Twinwall, PVC) to existing clay and concrete sewers from DN300 and above.

read more/DOWNLOAD or CALL 0114 257 0040
CONTRACTORS GUIDE 2018

Our new 2018 contractor guides are available.

DOWNLOAD here
TWISTEE SADDLE DN150

Connecting any DN150 lateral (Supersleve, Twinwall, PVC) to existing clay and concrete sewers from DN300 and above.

read more/DOWNLOAD or CALL 0114 257 0040
CONTRACTORS GUIDE 2018

Our new 2018 contractor guides are available.

DOWNLOAD here
TWISTEE SADDLE DN150

Connecting any DN150 lateral (Supersleve, Twinwall, PVC) to existing clay and concrete sewers from DN300 and above.

read more/DOWNLOAD or CALL 0114 257 0040
CONTRACTORS GUIDE 2018

Our new 2018 contractor guides are available.

DOWNLOAD here

MISSION EASY-REP flexible coupling kit for pipe repair

Data Sheet & Installation Guide    

EASY-REP is a rubber flexible repair coupling supplied in an easy to install kit form.

EASY-REP is designed to allow pipe repairs to be carried out to sewerage and drainage pipelines which have been subject to local damage or cracks, without the need to replace the section of pipe or even to stop the flow of water whilst carrying out the repair.

EASY-REP can be used to repair low pressure pipes of ALL pipe materials and once installed in accordance with the instructions, repairs are reliable, permanent and will resist an internal water pressure of up to 0.5 bar.

EASY-REP has been designed to the same profile of our Standard Coupling, with a width of 190 mm and is manufactured to customer´s specific size requirements.

It is essential to measure the outside diameter of the damaged pipe to ensure the best possible repair.

EASY-REP is available from DN 300 upwards.

MISSION´s TOX®-Technology eliminates spot-welds on the shear band and significantly enhances the ability to resist corrosion resulting in a more robust, longer lasting repair.

End clamps are manufactured from stainless steel grade 1.4301 (AISI 304) meeting the requirements of DIN EN 10 088-2, EPDM rubber sleeve manufactured according to DIN EN 681-1.